Extractor fan not working: causes and what to do
By Azzeddine Kebbi, NAPIT-registered electrician and director of Kebbi Electrical Services · Updated 11 November 2026
An extractor fan that has stopped usually has a blockage, a failed capacitor or a wiring fault. Some of these you can sort yourself; others need an electrician, especially if the fan is in a bathroom.
Check these first
- Is it getting power? Check the isolator switch (usually a pull cord or wall switch near the fan). Some fans also have a fuse in the ceiling rose or in the fan unit itself.
- Is the grill blocked? Dust and grease build up quickly. Remove the cover and clean it. A blocked duct also stops airflow even if the fan runs.
- Has it tripped the electrics? A fan with a faulty motor can trip an RCD. Check your consumer unit and see how to reset a tripped fuse box.
Common causes
Humming but not spinning
A seized motor or failed run capacitor. The capacitor is a small cylinder inside the unit and can be replaced by an electrician.
Spinning but not extracting
Blocked duct, broken backdraught shutter, or the fan turning the wrong way. Check the duct first.
Dead completely
No power (check isolator), blown internal fuse, or failed motor.
Coming on when it should not
Timer or humidity sensor stuck. Can sometimes be reset by turning off power for 30 seconds.
Bathroom fans: safety first
Bathroom fans are in a wet location and covered by the bathroom wiring zones in BS 7671. Work on them must be done with the power off. The fan is usually on a lighting circuit; turning off the lighting circuit MCB at the consumer unit isolates it, but confirm with a voltage tester before touching any wires. If you are unsure, call a qualified electrician.
When to replace rather than repair
- The motor bearings are worn and it makes a grinding noise.
- The unit is more than 10-15 years old and spares are not available.
- It was undersized for the room (flow rate should be at least 15 litres per second for a bathroom).
Common questions
Can I replace a bathroom extractor fan myself?
It depends on where it is and what work is involved. Swapping a like-for-like fan on an existing circuit outside the bath or shower zone may be possible for a competent DIYer in England and Wales, but wiring changes and fans close to the bath or shower must be done by a qualified electrician and notified under Part P.
Why does my extractor fan smell?
Mould or grease in the duct is the usual cause. Clean the duct and check for a cracked or disconnected pipe behind the wall letting damp air in.
How often should I clean my extractor fan?
Clean the cover every 3-6 months and check the duct is clear once a year.
My fan runs all the time. How do I turn it off?
Most fans have a timer or humidity sensor that can be adjusted. If yours is wired through the light switch with an overrun timer, it should stop a few minutes after you turn the light off. Check the instructions for your model.
