Dimmer switch not working? Common causes
By Azzeddine Kebbi, NAPIT-registered electrician and director of Kebbi Electrical Services · Updated 11 November 2026
Most dimmer problems come down to a mismatch between the dimmer and LED bulbs. Older dimmers were made for filament bulbs and cannot control the small load of LEDs properly, so the lights flicker, buzz, will not dim all the way or stop working. The fix is usually dimmable LEDs with an LED-rated dimmer.
First, stay safe
- If the dimmer is hot, smells of burning or crackles, switch off at the consumer unit and call an electrician.
- A dimmer that is slightly warm in use is normal. Too hot to touch is not.
Symptoms and causes
Lights flicker or pulse
The dimmer is not designed for LEDs, or the bulbs are not dimmable.
Lights will not dim low or switch off fully
The load is below the dimmer minimum. Common with a few low-wattage LEDs.
Dimmer buzzes
A mismatch, or too many bulbs for the dimmer.
Nothing happens at all
The dimmer module has failed, often after a bulb blew, or the circuit has tripped.
How to fix it
- Check the bulbs are marked dimmable. Non-dimmable LEDs must not be used on a dimmer.
- Use the same make and type of bulb on one dimmer.
- Replace an old dimmer with a trailing-edge dimmer rated for LEDs, sized for the number of bulbs.
- If it has stopped working completely, try a normal bulb or check the consumer unit before replacing the dimmer.
Common questions
Why has my dimmer switch stopped working?
The internal module can fail, often when a bulb blows, and overloaded dimmers burn out. Check the circuit has not tripped, then have the dimmer replaced.
Do LED bulbs need a special dimmer?
Yes, in most cases. A trailing-edge dimmer rated for LED loads gives smooth dimming without flicker or buzz.
Why do my lights not dim all the way down?
LED loads are often below the minimum the dimmer can control. An LED-rated dimmer with an adjustable minimum level usually solves it.
Is a warm dimmer switch normal?
Slight warmth is normal because dimmers give off a little heat. Hot, discoloured or smelling of burning means switch off and call an electrician.
Want dimmers that work with your LEDs?
See our electrical installations and repairs, or for urgent faults our emergency electrician service.
